When a Tub's Factory Finish Fails It Takes Real Repair Work

When a factory finish starts separating from the tub surface, a simple patch job won't cut it. The coating lifts, cracks spread, and before long you've got chunks of material peeling away - exposing the raw tub underneath. That's exactly what we were dealing with here. The original finish had given out in a big way, and the damage was too far along to ignore.

The first step was stripping out all the failed material. No shortcuts. If you leave compromised coating behind and just spray over it, the new finish will fail too - usually pretty fast. We got down to the bare surface, assessed the weak spots, and built things back up properly before anything else happened. That prep phase is where most of the real work lives on a job like this.

Once the surface was solid, we worked through the repair and rebuild process - reinforcing the areas that needed it and getting everything level and consistent. The filler work you see mid-job is part of making sure the final coat has something stable to bond to. It's not glamorous, but it's what separates a finish that lasts from one that peels again in six months.

Then comes the reglazing. We sealed and refinished the entire tub, laying down a smooth, even topcoat that bonds tight to the repaired surface. The result is a tub that looks factory-fresh and - more importantly - is structurally sound again. No peeling edges. No exposed patches. Just a clean, hard finish that's ready for daily use.

If your tub is peeling, cracking, or showing signs that the surface is separating, that's not something that fixes itself. We handle tub repair and refinishing across Milwaukee, Wisconsin, Illinois, and Florida - and we do it the right way, from prep to final coat.