Tub Refinish in Whitefish Bay Done the Right Way

This one was all about doing the prep work right. Before any coating goes on, we strip the surface down to bare material - no shortcuts, no skipping steps. That's the only way to get a bond that actually holds and a finish that doesn't peel six months later.

We also pulled the glass panel completely before starting. It sounds like a small thing, but it matters. Leaving it in place means you're masking around it and missing corners. Taking it out means every single inch of the tub gets coated evenly. That's the difference between a finish that looks right and one that actually is right.

A lot of tub refinish jobs fail early because the prep was rushed. We've seen it - coatings applied over old residue, edges that were taped instead of properly cleared, surfaces that weren't worked down to a clean base. That's not how we operate. The extra time upfront is exactly what makes the finish last.

The end result is a high-gloss, bright white surface that looks like a brand new tub. No staining, no dull spots, no rough patches. Just a clean, smooth finish that holds up to daily use. Tub refinishing is a fraction of the cost of replacement, and when it's done correctly, it performs like one too.

Whether your tub is stained, worn down, or just looks rough no matter how much you clean it, refinishing is worth a serious look. We serve Whitefish Bay and the surrounding area - and we bring this same level of prep and care to every job we take on.